Hi, I have bought 5 Wii-clip V4C with a D2pro-9 already soldered, from (www satkit com); they are exactly like this:
http://www.wii-clip.com/images/V4C_D2Pro_9wires-3.JPG
but missing some soldering respect to the picture, and have CLK jumper already closed.
4 clips were mounted on Wii with D2E chip, and all are working perfectly.
Last clip was mounted into a Wii with D2B chip, and this don't work.
First try: mounted "as is": Wii had an original DVD already inside. When I turn on the Wii, it don't read the Disc, and I can't eject it.
Second try: removed the dvd, new boot of Wii: it don't accepts discs, the DVD drive seems "closed".
Third try: removed the soldered jumper CLK on the wii-clip, and soldered a wire between the J points, as read on your website: now can get discs in and out, but don't read discs.
4th try: found on a forum, that "for D2B, only 5 points are needed: GND, 3V3, G, H, J". So I removed the soldering between Wii-clip and d2pro-9 on points 9, C, D, E, F. But don't work
5th try: fuond on another forum, something that say "to turn on and off the chip you can mount a button between GND and point K. Uhmmm, my chip has alway a fixed red led, so I think it is turned off. so I have tried to make contact for point K between wii-clip amd d2pro with a screwdriwer. Suddenly a blue led lights on D2pro, red led turn off, and all works ! So I have made a soldering for point K, but when I mount he clip again, it don't work again.
Now I have understood that making some pressure in the zone near point K-L-M cause the chip to "start" and then all work fine, even with backup discs, but I don't understand which is really the problem. Maybe a bad clip ? a bad D2Pro ?
I don't undersand WHAT makes "contact" when I make pressure on the clip/chip !! Which are the exact points that needs to be soldered, for a D2B Wii (not cut-pin) ??
Please HELP !!
Thank you
Ser
Problems with D2PRO-9 and Wii-clip
