Looks like you were wrong. There were a couple motors complicating the board swap. I unsoldered the two motors taking careful note of the orientation (six wires total). I swapped both boards and soldered the motors back on. It was simple and it went smoothly.
Unfortunately, neither drive works.
The original GC2-DMS drive, having had the GC2-DMS board replaced with a stock D2C board, now spins and results in a "?" on the disc channel. Of course, this drive didn't read discs in the first place, but at least it tried longer.
The original D2C drive having had the D2C board replaced with a GC2-DMS + WiiKey now spits discs back out immediately. Bah!
|